Super 2600mAh Battery V2

Version 2.

Copper Construction. 510 threading.

Size: length 105mm - bottom diameter 20mm - threading diameter 9.2mm.

The central pin inside the battery is adjustable. If it doesn’t work with atomizer or cartomizer, please try to pull the pin up with tweezers for better contact.

Battery Options:

18650 Blue Lithium Ion Battery - 2600mAh - Protected - 3.7 to 4.2 volts depending on charge level. Can be charged inside the case body like an eGo Battery using any eGo USB charger. Button turns green when charged. Allow a full charge before first time use. Initial charge can take 6-8 hours. Works good with most cartomizer and atomizer setups over 2.2ohms.

--------

18650 Ultrafire Lithium Ion Battery - 3000mAh - Protected - 3.7 volts. Works good with most cartomizer and atomizer setups over 2.2ohms.

--------

18650 AW IMR Battery - 1600mAh / 2000mAh - These are NOT protected batteries but are the safer battery chemistry LiIon.

They are intended to be used for high drain applications.

Works with 18650 multi-chargers.

IMR cells have much lower internal resistance than regular LiIon 3.7V cells and they may end up with a higher ending voltage when charged in certain chargers ( especially older version WF-139 charger ). Please check the voltage of your battery right out of the charger to see if they are above 4.20V when fully charged with your charger. Overcharging above 4.25V may shorten life/cycles. Above 4.50V may even damage them.

DO not use the charger if it is overcharging IMR cells.

Do not over charge or discharge these LiMN batteries. Do not short circuit these LiMN batteries or dispose of in any type of fire.

Please still excercise caution when working with LiMN cells and do not leave them unattended when charging. Only use a battery charger rated for 3.7v batteries to charge these batteries.

3.7 Volts.
Peak Voltage: 4.2 Vol.t
Dimensions: 18D x 65H mm (+/- 0.5mm).
Weight: 40 (+/- 2) grams.

Works good with most cartomizer and atomizer setups irrespective of ohms.

--------

The following guidelines should be strictly followed:

1. Only recharge these devices with the intended charging cable or adapter. Using chargers with incorrect voltage or current can cause a fire or catastrophic failure.

2. Never leave a charging battery unattended.

3. Never charge a battery overnight while you sleep.

4. Never leave a battery on your charger longer than necessary. When it is full, unplug your charger and remove the battery. Leaving a battery on charge when it is full will degrade it’s performance and may result in a fire.

Indy Vapor Shop will not be held responsible or liable for any injury, damage, or defect, permanent or temporary that may be caused by the use of any battery. Please have a basic understanding of the batteries you are using and how to care for them properly.

Read the information found at: Battery University before purchasing. It is important to carry batteries properly, recharge properly, and dispose properly.